Pipe Mold

• Concrete Pipe Mold

  Pipe tooling determines the finished outer shape, joint geometry, and the way a pipe releases after forming. A Concrete Pipe Mold may be designed as a flat-joint mold, socket-and-spigot mold,...

  Read More
• Concrete Pole Mold

  Concrete poles vary in length, taper, reinforcement, and process requirements, so their steel tooling needs to follow the actual pole design. A Concrete Pole Mold is normally used with a pole...

  Read More
• Cement Product Plastic Mold

  The Cement Product Plastic Mold is designed for cement products that require specific shapes and dimensions. Because finished products can vary significantly in appearance and size, this type of...

  Read More
• Cement Pipe Rubber Ring

  Sealing-ring selection starts with the pipe joint, not with a generic ring name. A Cement Pipe Rubber Ring is supplied according to the cement-pipe diameter, joint profile, and confirmed...

  Read More
• Concrete Pipe Rubber Gasket

  For reinforced concrete pipe the joint gasket works under more load than in a cement pipe line: the pipe is heavier, the joint may be deflected during laying, and the ring has to hold its seal...

  Read More
• Cement Pipe Rubber Gasket

  A cement pipe rubber gasket is the sealing element in a socket-and-spigot joint: the ring sits in the spigot groove, the spigot is pushed into the socket, and the compressed rubber closes the gap...

  Read More
• Manhole Chamber Mold

  A manhole chamber mold forms the precast inspection chamber used where a drainage line needs access: the chamber body, its base and the reducing rings above it. The tooling is usually a pair — an...

  Read More
• Plastic Mold For Concrete Products

  Concrete products formed in plastic tooling are usually the ones with a shaped face: stamped pavers, retaining wall blocks, decorative panels, kerb units and similar precast items where the...

  Read More
• Plastic Mold For Cement Products

  Plastic molds are used where the product shape matters more than the number of pieces: cement products such as covers, edging, decorative panels and small precast units are formed in plastic...

  Read More
• Concrete Pipe Pile Mold

  A pipe pile mold is a long, prestressed cavity, and its working life is harder than a drainage pipe mold's: the pile is spun at speed, steam cured, stripped, and the same shell is returned to the...

  Read More
• Concrete Utility Pole Mold

  A concrete utility pole is a tapered, prestressed section, and its mold is built around the pole design rather than around a standard diameter: the cavity follows the taper over the full length,...

  Read More
• Vertical Vibrating Cement Pipe Steel Mold

  Vertical vibration exposes a mold to a load pattern that other forming routes do not: the shell is filled, vibrated at high frequency while the mix is still confined, then opened and stripped, and...

  Read More